TECHTONGDA LED UV Exposure Unit Equipment for Silk Screen Printi
TECHTONGDA LED UV Exposure Unit Equipment for Silk Screen Printi
- Make sure this fits by entering your model number.
- 【UV LED Lamp】This UV Exposure Unit adopts 20 pcs of LED lamp beads, the total power is 20W (equal to a 200W ordinary ultraviolet lamp), the wavelength is 365nm , the exposure lamp size is 5.5*4 inches; LED plate lamp service life can be up to 50,000 hours.
- 【Flexible Structure】 The height of the lamp can be adjusted according to specific need. The distance bet the lamp and plate can range from 1.2" to 7.8". The lamp can rotate by 280°.Adopts two-way clamps for convenient heights and angle adjustment to meet different exposing demands
- 【Wide Application】This machine is mainly used for making screen plate in screen printing, pad printing, hot stamp printing, etc. The image can be perfectly transferred from the film to the screen.It can also be used for curing products whose wavelength of 365nm.
- 【BETTER EXPOSURE EFFECT】 A black rubber subplate (9.8"x9.8") is equipped for reducing the ultraviolet reflection during exposing, in order to get a better exposure effect.
- 【CONVENIENT OPERATION】Equipped with a glass sucker for much more convenient, easier taking of glass.The countdown timer will make sure you get the perfer exposing effect.
Product Description
This UV Exposure Unit adopts 20 pcs of LED lamp beads, the total power is 20W (equal to a 200W ordinary ultraviolet lamp), the wavelength is 365nm , the exposure lamp size is 5.5*4 inches; LED plate lamp service life can be up to 50,000 hours.
The light can rise and fall according to the need , the minimum distance from bottom of the machine to the surface of the desktop is 3 cm, the highest distance is 20 cm.
The machine can be installed in two ways: it can be directly clamped in the table edge with thickness of 1 cm to 5 cm ; It can also be fixed directly on the table with self - tapping.
The lamp can be expanded and rotated according to the need; Maximum extension distance is 36 cm (LED light center); The lamp holder can be rotated in 280 degrees. After using, the lamp holder can be rotated outside the table.
In order to facilitate the user to exposing, the machine is additionally equipped with a flat 25*25 cm rubber plate with thickness of 2mm, a glass chuck and a countdown timer.
The operation methods is as follows
1.Spread the black rubber on a flat table.
2.Place the coating mesh frame on the rubber sheet, and stick the mesh side to the rubber sheet. 3.Put the film on the top of the mesh exactly (in order to prevent the film sliding, it is best to use a little transparent tape to stick the film and the four sides of the mesh together);Use a glass sucker to lift the glass and place it on the film;(This machine is not configured with the glass for transportation safety, users can configure locally according to the frequently used size, 4-5 mm glass plate is appropriate).
4.Move the machine to the top of the screen frame. The distance between the lower edge of the case and the screen frame is 3-5 cm.According to the actual exposure time of photosensitive adhesive to set the countdown time.
5.Turn on the power and start the countdown timer.
6.After the countdown, the timer beeps and lights off, remove the machine, take out the glass and film, exposure is completed.